New releaseDAPs

HiBy's RS2 II brings the Darwin III R2R platform to a $439 compact player

The second-generation RS2 inherits the resistor-ladder architecture and FPGA engine of HiBy's flagship, with a 3.55-inch screen, dual microSD and a 500-unit brass edition at $549.

HiBy's RS2 II brings the Darwin III R2R platform to a $439 compact player
HiBy's RS2 II brings the Darwin III R2R platform to a $439 compact player · Image: HiBy

HiBy has launched the RS2 II, a compact digital audio player at $439 in aluminium, with a brass edition limited to 500 units worldwide at $549. It is built on HiBy's DARWIN III architecture: a resistor-ladder DAC run by an FPGA engine of more than 35,000 logic units and 40 DSP units, followed by four OPA1612 and four OPA1622 devices. Japanese coverage quotes 630 mW from the 4.4 mm balanced output and 172.5 mW single-ended, a 3,500 mAh battery rated at about nine hours, and a Japanese release on 30 October. It has a 3.55-inch 480 x 800 screen, two microSD slots for up to 4 TB, coaxial and line outputs, and USB DAC operation.

In a ladder DAC the resistors set the linearity, but here the FPGA sets almost everything else: the filters, the oversampling and the NOS option all live in its firmware. That makes the RS2 II several converters in one box, and each filter mode will measure differently. The 630 mW figure was published without its load, which leaves the most practical question, what it will drive, still open.

All DAPs launches

Back to all new releases.